Product Detail

Verawood - DynaVap Stem - XXL Size - Aromatic

Title

$60.00


 

Add Ons

Note the photos for this piece were taken right after it was made, after some exposure to light the wood actually turns green! 

 

Custom DynaVap stem or mid section made from wood. 

This is an upgrade piece to replace the main body of any DynaVap vaporizer.

Compatible with all DynaVap vaporizer Tips.

All DynaVap components are removable for easy cleaning, and also to accessorize with cool upgrades like this one.

The Tip can pressed in to fit and held with it's o-rings.

Size: XXL
Length: 4.12"
Diameter: 0.6"

* vaporizer not included

*Note this listing is for a stem made from the type of wood shown. Wood always has some natural variation in grain and color and will be very similar to but not exactly the same as the one in the photos.

Instructions:

1. Pull out the "tip" from your DynaVap. It's held in with 2-3 o-rings and should easily pull out. This is the same procedure that should be done from time to time for cleaning.

2. Clean and lubricate the o-rings. This step is important, we recommend using some of the wax that's supplied with your DynaVap on the o-rings. A bit of mineral oil or food safe oil like walnut oil is also ok, or any salad bowl wood finish - which means it's food safe and usually just a mix of mineral oil and beeswax.

3. Press the tip into the ribbed end of your new mid section. It's a firm fit, and with a little pressure and twisting it will seat fully. On some tips when fully seated the last o-ring will still be visible, this is ok.

4. If you have a model of DynaVap with a condenser, which is a replaceable tube extending from the draw end (the mouth piece end), you can also optionally use it. Push the condenser out from the inside and you'll see it's held in with flexible rings which easily compress. You can then push it into the smooth end of your new stem until the last flexible ring is flush.